This study guide only covers the OSHA portion of the PSI exam.
PSI OSHA Selections, 2013 Study Guide
$49.95
We advise that you NOT purchase the PSI published book shown in the exam bulletin. We recommend a better, up-to-date allternative on our Study Guides purchase page linked below.
The button below will take you to the details about our 800 question Study Guides and provide you with a FREE "Reference Navigator" document that allows you to more accutately decide which sections of the federal code applies to your exam. PSI does not provide this information.
Apply for the License
Nevada State Contractor‘s Board 2310 Corporate Circle, Suite 200 Henderson, NV 89074 Phone: (702) 486-1100
Exam Provider
PSI Clark County Office 450 N Stephanie St. Henderson, NV 89014 Phone: (855) 205-5827
Exam Type
OPEN BOOK
Exam Content
The official exam bulletin is published and maintained by PSI. Bulletin content (subjects covered in the exam), time allowed and passing score are detailed in this document. Direct links to bulletin PDFs change regularly. Always set your “FAVORITE” or “BOOKMARK” to the landing page we have linked above. Candidates should always review the current exam information on the PSI website before submitting their license application.
Scope of Work
Fabrication and installation of sheet metal, including, without limitation, cornices, flashings, gutters, leaders, downspouts for rainwater, pans, food service equipment, ducts, louvres, patented chimneys, flues, and metal roof systems, but not the fabrication or installation of equipment which uses refrigeration as an integral part of the system.
This exam may also include questions on the following subjects:
Reading and interpreting construction codes and regulations
Nevada Health Department regulations
Appropriate building codes
Trade materials, tools, equipment and methods
Nevada Occupational Safety and Health Rules
Books Allowed in the Exam
1.
Uniform Mechanical Code, 2018, IAPMO
2.
International Building Code, 2018, ICC
Books NOT Allowed in the Exam
1.
HVAC Duct Construction Standards - Metal and Flexible, 3rd Edition, 2005, SMACNA
2.
Sheet Metal, 2nd Edition, 2006, Leo Meyer
3.
Architectural Sheet Metal Manual, 6th Edition, 2003, SMACNA
